Living in an apartment complex where everyone has WiFi can do this. That much of a difference in speed between wired and wireless speed tests can mean that there's something wrong at the wireless access point level or your wireless environment is just too congested. A word of warning: expanding channel widths can cause channel overlap and interference/slowdowns with your neighbour's WiFi, so only attempt to do this if your wireless environment allows.Ĭ. The AC23 has 4x4 MU-MIMO, but most client devices only support 2x2. That 1733Mbps on 5GHz is again, only attainable within close range of the access point's antenna, no physical obstructions, no wireless interference, and most times, on wide channel widths (80MHz, 160MHz, or the widest your access point supports) and if both AP and client device support MIMO. This might lead to compatibility issues for legacy devices, but that is required to get 300Mbps on 2.4GHz, which is still subject to the limitations in 'A'. So you have to turn off support for 802.11b/g and allow a channel width of auto 20/40MHz. 300Mbps on 2.4GHz is if you use 802.11n on the 2.4GHz band and, usually, this only applies when channel bonding is in effect. ideal conditions must be met, absolutely no wireless interference, absolutely no obstructions, etc.), so in the real world, you only get a fraction of the stated throughput.ī. Furthermore, the speeds quoted by wireless router manufacturers are theoretical (i.e. More money, and still likely won’t get you up to ethernet speed - WiFi can actually attain higher speeds than ethernet in some cases, but that speed will never be as consistent and reliable as ethernet. You can lower the range by doing a mesh system or adding repeaters. Range and obstructions and interference can make huge differences. You mean make the WiFi faster? The issue is WiFi is radio and it’s very power limited for safety. With my Iphone X, the result varies with my other devices on average 20- 40 Mbps. (2.4 Ghz)īecause my router is Dual Band (2.4 Ghz & 5 Ghz), i also tried it with the 5 Ghz wireless, and here's the result : The specs of my router can be checked through this link : Īfter i install the new router and disabled my modem Wireless AP, i checked the speed again with my Macbook Air 2017 and it got just around 20 - Little bit under 40 Mbps. So i bought a new router to connect it with the modem, the router that i bought is Tenda AC-23 AC2100 Dual Band Gigabit Router. I got really frustrated because it won't go up more than 20 Mbps, and i know Wi-fi is slower than Ethernet but i don't expect it to be this bad. I just got 100 Mbps internet service from my local ISP and they gave me this cheap Nokia g-240w-f as main modem and it has built in Wireless AP so i don't need a new router.Īt first i tried the speed test from my PC which was connected by Ethernet to the modem and it got normal speed around 90-100 Mbps in .īut when i tried it from my Iphone X with Wi-fi, it only got 10-20 Mbps, same thing happened with my Macbook Air 2017 and other Devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |